Back to Blog
![]() If you have a microphone connected to channel 1, make sure the MAIN button is pressed on channel 1 in order to assign that channel to the main mix. Make sure channel 1 MUTE button is not pressed. Starting from the top of the channel ‘strip’ for channels 1 through 6: Make sure there are no SOLO buttons pressed on any of the channels. LINE IN input ¼” balanced (TRS) or unbalanced (2 -conductor) signal MIC input XLR balanced connection for a mic or similar low impedance signal (Note: Many of these controls are covered in greater detail (with examples) in the application guides that follow) INSERT jack a ¼” TRS 3-conductor jack (located on the back of the mixer) that acts as both a send and return to be used with a processor, like a compressor or effect unit. A special insert Y-cable is used, with a ¼” Tip/Ring/Sleeve on one end, and two ‘mono’ 2-conductor (Tip/Sleeve) connectors on the other end. LO CUT button when this is pressed in, it engages a filter that cuts the low frequency range at 75 Hz and below, to remove stage ‘rumble’ and similar sounds. Behringer xenyx x1204usb overview manual#. ![]()
0 Comments
Read More
Leave a Reply. |